This is the eighteenth, in a series of twenty-four Point file translations. The file Geometry.Point.Project.OnSolid.WithDirection.ds is located in the DesignScript Editor (DSE) Sample files.
Open the file Geometry.Point.Project.OnSolid.WithDirection.ds in the DS Editor, and run it. We get an initial error on line 11 of the script as shown below. Looking at the error report its seen that the “Project along direction operation failed.”
The DesignScript Editor reports the errors as highlighted above.
Nonetheless, open DS Studio, and paste the DSE script, Geometry.Point.Project.OnSolid.WithDirection.ds into a blank canvas. The preliminary translation shown above produces the error, it’s illustrated further below.
Using the previous file “Geometry.Point.Project.OnSolid” we can use the Project node and continue.
Again, the red and yellow highlighted areas indicate the groupings of nodes according to their properties. With the translation as complete as can considering the error, the “Node to Code” operation takes place.
At least the failure is consistent throughout the translations. Let hope that the DesignScript team will fix this along with the rest of the errors. 🙂
The geometry that results from the code(s) is shown below. Note that liberty was taken with applying colors to the translation.
The files are available to download from the DropBox links below.
Thanks for looking.